Assembling And Unfolding The Handle - Toro 21025 Operator's Manual

Setup
1. Assembling and Unfolding
the Handle
Procedure

Assembling and unfolding the handle

improperly can damage the cables, causing an
unsafe operating condition.
• Do not damage the cables when assembling
and unfolding the handle.
• Ensure that the cables are routed to the
outside of the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Unlock the handle locks, move the handle sections
into the operating position, attach the upper handle
to the lower handle, and lock the handle locks
(Figure 3).
1. Handle lock (4)
2. To adjust the handle height, unlock the upper handle
locks and rotate the upper handle upward and lock it
into a position that is comfortable for you (Figure 4).
1. Highest position
2. Middle position
Note: You can set the upper handle to 1 of 3 handle
positions. Line up the mark to one of the 3 marks on
the inner side of the upper handle locks (Figure 4).
5
Figure 3
2. Upper handle end
Figure 4
3. Lowest position