Advertisement
SYSTEM FUNCTION
HUMIDITY CONTROL: When the humidity reaches
the set point, the machine will stop automatically.
It will automatically start the machine when the
humidity in your space rises above the set point.
The humidity range is 30-90%; The machine will
stop +5% of set humidity and restart below -5%
of set humidity.
WATER INLET: When the water level in the water
tank decreases, the float switch will activate and the
water tank will refill automatically and stop filling
when the water level rises to the maximum height.
TECHNICAL PARAMETERS
Model
Power
Supply
Voltage
115V/60Hz-
701600
1 Phase
ERROR CODES
Code
E1
E2
TROUBLESHOOTING TIPS
Failure
Dehumidifier doesn't
work
Dehumidification is
not ideal
Water leak
Abnormal noise
If the above troubleshooting does not fix your issues and repair, please contact Ideal-Air
technical support. Do not disassemble without authorization.
Power
Range
(Watts)
12.31 Amps/
41° F- 95° F
1350W
Meaning
Temperature sensor failure
Coil sensor failure
Cause Analysis
1. Power cut
2. Power switch is not energized
3. Power cord is not connected
4. Fuse is melted
1. Dust accumulated in air purification filter mesh
2. Object blocking air inlet and outlet
3. The door or window is open
4. Refrigerant is leaking
1. The machine is inclined
2. Water pipe is blocked
1. The machine is not placed solidly
2. The filter mesh is blocked
LOW WATER LEVEL WARNING: When the
system detects the water level is lower than the
warning level, the machine will stop automatically.
The system will warn if water is not refilled in 10
minutes.
FAN DELAY PROTECTION: When the
humidifier is turned off the fan will continue to run
for another 30 seconds to drain all the residual
water and cool the unit.
Condensation
Removal
(24 hrs)
180 pints
(86° F, 80% RH)
Method
1. Recover the power
2. Energize the power
3. Connect the power cord
4. Replace the fuse
1. Clear the filter mesh
2. Remove the blocking object
3. Close the door and window
4. Contact distributor or manufacturer for repair
1. Level the machine
2. Remove the blocking object
1. Place the machine firmly.
2. Clear the filter mesh
Size
N.W.
(inches)
(lbs)
22.5" x 23" x 40"
135 lbs
™
Advertisement
