Markers FT160-19-DLUX Quick Start Quide

FlexTension Fence Kit #FT160-19 includes:

160 ft Pocket Net Fence, 5 Stabilizing Poles,
14 Flex Poles, Installation Accessories
Tape Measure • String • Chalk or Spray Paint • Mallet or Drill • Sharp Scissors (if cutting is required)

A - Lay out fence line

Using tape measure lay out the radius. Chalk
or paint the line where fence will be installed.

B - Mark pole locations

Starting at foul line, mark 19 pole locations approx. 8.5 ft. apart
for each 160 ft. set.
Note: If using multiple sets, mark end locations close together
between each set. You can allow for openings 2 ft. wide between sets
for a gateway, or keep them close for a fence with no gateway.
(see 3 diagrams below)
1 Set Pole Layout
100 ft. to Home Plate
Foul Line
2 Set Pole Layout
Set 1
200 ft. to Home Plate
Foul Line
3 Set Pole Layout
These can be (2) 2 ft.
Set 1
gateways if desired
300 ft. to Home Plate
Foul Line
Suggested positions when installing 2 or more fence rolls (L-R)
A - Continuous run - set end poles side by side or tight overlap
First set
B - Overlap gate - pass-thru.
repeat as needed
First set
for 3rd set
NEW
featuring Pocket-Net
For easier installation, pockets are located every
3 inches to secure the fence to each support pole.

YOU MAY ALSO NEED THE FOLLOWING TOOLS:

Foul Line
This can be a 2 ft.
gateway if desired
Set 2
Foul Line
Set 2
Set 3
Foul Line
2nd Set
2nd Set
First set
2nd Set
1-800-969-5920
Technology
TM

FlexTension Fence Kit #FT160-19-DLUX includes:

160 ft Pocket Net Fence, 5 Stabilizing Poles, 14 Flex Poles,
Installation Accessories, 19 Ground Sockets

Installing Poles / Ground Sockets

ALWAYS Make
Pilot Holes
Drive Pilot Hole
Tool into ground
with hammer or
rubber mallet.
Gently tap
Pilot HoleTool
from right to left
to loosen &
remove from
ground.
Ground Sockets
Push Socket as far as
you can into ground.
(OVER)
info@markersinc.com
Outfield Fence
471 linear ft.
3 sets
314 linear ft.
2 sets
157 linear ft.
1 set
Hint:
For Faster Work,
Drill Pilot Hole using our
optional Auger - 1" dia. Fence Poles
x 10" deep.
Socket
Setter
Pilot
Hole
Use the supplied Socket
Setter and drive Ground
Pole into socket
Socket into the ground.
File: Flex Fence instr pg1 of 2 (2018)
www.markersinc.com
Use
Rubber Mallet
on posts!
Installing
directly
into pilot
hole
Pilot Hole
Make sure
the Socket is
flush with the
turf line.
Insert fence