Advertisement
Setting up your wireless speakers
Powering On/Off Speaker:
Move the power switch to the On position. Press the button marked Standby/Sync on the back of each speaker
once to turn on. An green indicator light will turn on or flash (see below). Press the button again to place each
speaker into standby mode and move the power switch to the off position, if desired. Note that each speaker will
automatically switch to a low power mode approximately 30 seconds after playback stops.
Syncing (all models):
In order for your wireless speakers to receive a signal from the wireless transmitter, they need to be synced/
paired. This process only needs to be performed once as all the components will remember each other, even after
disconnecting the power.
On the transmitter: Press and hold the Power/Sync or Sync button until the green light starts flashing rapidly.
On the first speaker: Press and hold the Power/Sync or Standby/Sync button until the green light is solid. Note
that the green indicator light on the transmitter will also now be solid.
Repeat the steps above for the second speaker and confirm that the green indicator light next to the sync button
is solid on the transmitter and both speakers. Your wireless speakers are now ready to use!
Recommendations:
The most reliable wireless signal quality will be achieved by placing the transmitter and speakers within "sight" of
one another. If you notice interruptions in the audio signal, try moving the transmitter to another location.
Advertisement
