Gigabyte Z690M A ELITE AX DDR4 User Manual page 24

F_USB3 F
_
_ _B
_
_ _B 10) M2A_CPU/M2Q_SB/M2P_SB (M.2 Socket 3 Connectors) _
There are two types of M.2 SSDs: M.2 SATA SSDs and M.2 PCIe SSDs. This motherboard only supports
M.2 PCIe SSDs. Be sure to verify the type of M.2 SSDs you want to use. Please note that an M.2 PCIe
SSD cannot be used to create a RAID set with a SATA hard drive. Please navigate to the "Configuring a
_
RAID Set" page of GIGABYTE's website for instructions on configuring a RAID array.
S F_
_
B_
S S_F
B
S F_
B_
S S_F
B
S F_
_
B_
S S_F
B
Follow the steps below to correctly install an M.2 SSD in the M.2 connector.
_
Step 1:
Locate the M.2 connector where you will install the M.2 SSD, use a screwdriver to unfasten the screw on
the heatsink and then remove the heatsink. (Only the M2A_CPU connector has the heatsink)
F_USB3 F_USB30 3
_
Step 2:
Locate the proper mounting hole based on the length of your M.2 SSD drive. If needed, move the standoff
to the desired mounting hole. Insert the M.2 SSD into the M.2 connector at an angle.
Step 3:
F_USB3 F_USB30 3
Press the M.2 SSD down and then use the included screw to secure it in the connector. Remove the
protective film from the bottom of the heatsink. Then replace the heatsink and secure it to the original hole.
F_USB3 F_USB30 3
* Types of M.2 SSDs supported by each M.2 connector:
M2A_CPU
M2P_SB
M2Q_SB
If you want to install an operating system on an M.2 PCIe SSD, you need to install the Intel
VMD Controller driver first. Refer to Chapter 4 for more instructions.
S _
S _
110
M.2 PCIe x4 SSD M.2 PCIe x2 SSD
a a
a a
a a
- 24 -
_ F
_ 0
_ F
_ 0 F
_ F
_ 0 F
_ 0 F
80 60
80 60
_3 U
80 60
_3 U
_3 U
M.2 SATA SSD
r
r
r
M2A_CPU
M2Q_SB
M2P_SB
RST
®