Safety Precautions; Body Assembly - Crown FT-30MC Instruction Manual

SAFETY PRECAUTIONS

When using any electrical appliance, basic safety precautions should always be followed, including the following:
1. Read all instructions and keep for future reference.
2. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
3. Young children should be supervised to ensure that they do not play with the appliance.
4. Always unplug the appliance from the mains when not in use.
5. To disconnect the appliance, switch the control to OFF, then unplug from the mains.
6. To unplug the appliance, always grasp the plug; do not pull the cord.
7. If the supply cord is damaged it must be replaced by the manufacturer, its service agent or a similarly
qualified person in order to avoid a hazard.
8. Do not use outdoors. This appliance is designed for household use only.
9. Place the power cable away from areas where people walk so that it cannot be stepped on or tripped over.
10. Always use the appliance on a flat, stable surface.
11. Never clean this appliance when it is plugged in .Do not immerse it in water, clean the outside surface with a
damp cloth or soft brush and dry with a soft dry cloth.
12. Use the appliance only as directed in this manual. Misuse could void your warranty.
13. Avoid contact with moving parts, never insert any objects through the grille when the fan is in operation
ASSEMBLY INSTRUCTIONS

Body Assembly

1. Unscrew the Ring and Base Locking Screw from the Pipe.
2. Insert the Pipe through the hole in the center of the Base and twist into positio
3. Tighten the Base by Ring and Base Locking. Screw
4. Unscrew the Locking Nut from the Fan Head.
5. Put the Fan Head into the Pipe, and using the Screw to tighten the Fan Head and the Pipe.
Fan Grill Assembly
1. Fasten the rear grill onto the motor with four screws.
2. Install the Blade onto the Motor Shaft by tightening the blade screw.
3 Centre the Front Grill by aligning the logo on the grill Hub so it is horizontal and parallel to the floor. Then
.
secure the Front and Rear Grills completely together by snapping grill clips into place. Lastly, tighten the grill locking
screw at the bottom of the Rear Grill.