Bosch Dremel Stylo+ Original Instructions Manual page 9

collet and collet nut will provide a more precise accessory
holding solution especially in more precise applications such
slipping in the chuck, use the included wrench to tighten the
A.
B.
WARNING
!
8. With the shaft lock engaged, tighten the chuck using the
DO NOT USE ROUTER BIT WITH THE
WARNING
!
collet nut and give the accessory or collet a 1/4 turn. Re tighten
able to tell by the sound and feel if your accessory is running in
achieved. To maintain balance on abrasive wheel points, before
each use, with the wheel point secured in the collet, turn on the
revolving wheel point. This removes high spots and trues up the
wheel point for good balance.
install a different collet, remove the collet nut and remove the
end of the tool shaft. Replace collet nut on the shaft.
WARNING
!
A. Collet Nut
B. 480 3.2mm Collet
C. Shaft
GisDocView (ZVS-EMEA): DV-2610Z09751-MUL-AB, downloaded 2018-11-21 01:55:37 UTC by zce2sgh - PT-RT/MKT-AP (9/42)
E. 483 0.8mm Collet
F. 482 1.6mm Collet
G. 481 2.4mm Collet
collet.
especially if a collet nut is tightened onto the tool without a bit
in the collet nut. This should cause the collet to pop out of the
collet nut.
mechanism.
WARNING
!
the collet nut if necessary. The collet nut must be loosely
threaded on when inserting an accessory. Change accessories
by inserting the new one into the collet as far as possible to
With the shaft lock engaged, use collet wrench to securely
tighten the collet nut
of the collet nut when there is no bit inserted.
A. Collet Wrench
B.
C. Collet Nut
To Tighten
E. To Loosen
it in your hand and feel its weight and balance. Feel the taper
of the housing. This taper permits the tool to be grasped much
damaged during handling and can fly apart as they come up
When holding tool, do not cover the ventilation openings with
tool's high-speed action performs. Keep in mind that your
multitool will perform best by allowing the speed, along with
and allow it to touch the point at which you want to begin.
gives the best control and reduces the chance of error.
9
USE