Summit SCR489OS User Manual page 8

INSTALLING THE DOOR HANDLE
This beverage cooler includes a stainless steel handle that is not required to operate the unit. To
install the handle, follow the instructions below:
1. Remove the door gasket on the side you wish to install the
handle - you can see two designated holes for handle
installation. The gasket is easily displaced by hand, no tools
are necessary.
2. Install the handle tightly as shown with two screws and flat
washers provided. (DO NOT over tighten as this will cause
damage to the handle and stainless steel door frame).
3. Replace the door gasket to its original position.
REVERSING THE DOOR SWING (if desired)
Hinge
5. Take out the hinge cover
cover
handle hole caps.
12. Finished.
4. Take out the caps
on the holes
Handle
hole caps.
6. Remove
Screws
11. Assemble the
upper door hinge and
screws to the other
side and lock the
cover.
10. Hold tight and set
the glass door
downwards on the
lower door hinge.
9. Assemble the
lower door hinge to
the other side, and
assemble the screws.
7
Gasket
Flat Washer
Screw
1. Remove the hinge
cover, screws inside
and then the hinge at
the same time.
2. Hold tight and pull
the door upwards and
off carefully.
3. Remove the screws
and lower door hinge.
Handle
hole caps.
7. Take off
8. Assemble the
the handle.
hinge cover
handle hole
caps.
Handle
Door Frame
Hinge
cover