Gigabyte Z690I AORUS ULTRA User Manual page 29

19) F_AUDIO (Front Panel Audio Header)
The front panel audio header supports High Definition audio (HD). You may connect your chassis front
panel audio module to this header. Make sure the wire assignments of the module connector match the
pin assignments of the motherboard header. Incorrect connection between the module connector and the
motherboard header will make the device unable to work or even damage it.
Suggested F_AUDIO header routing:
Step 1:
Use a screwdriver to unfasten the screw on the
heatsink and then remove the heatsink.
Heatsink
GC-Z690I
BTB PLUG
F_ U
Please visit GIGABYTE's website for details on using the front panel audio header.
Some chassis provide a front panel audio module that has separated connectors on each wire
B_
instead of a single plug. For information about connecting the front panel audio module that has
different wire assignments, please contact the chassis manufacturer.
Step 2:
Use a screwdriver to remove the screw from GC-Z690I BTB
PLUG. Lift the GC-Z690I BTB PLUG upwards and remove it.
GC-Z690I
Default location of
BTB PLUG
the F_AUDIO header
Step 3:
Move the F_AUDIO header out of its default location and route
it via the BTB connector to the bottom edge of the motherboard
as shown on the left.
Step 4:
Insert GC-Z690I BTB PLUG vertically into the BTB connectors
and secure it with the screw. Then screw the heatsink back on.
Pin No. Definition
9 1
F_
10 2
B S S
1
_S
- 29 -
S
Pin No. Definition
1 MIC2_L 6
2 GND 7
3 MIC2_R 8
4 NC 9
5 LINE2_R 10
Sense
GND
F_
No Pin
LINE2_L
Sense
_
B