Advertisement
Control Box Pin-out
Troubleshooting guide:
Pin Color
J2
Red
+12V when switched on and +0V when switched off. Ignition
must be greater than +10V while cranking vehicle.
Lowest resistance to ground and closest to zero (0) ohms as
J2
Black
possible. Use a vehicle ground point where other ground
J3
Vio/Red
J3
Vio/Blk
J3
Yel/Grn
J2
Wht/Brn
Negative side of the brake switch: +0V and 0 ohms to ground
when brake is not pressed. +12V when brake is pressed.
J2
Blue
Desired Results
wires are connected to.
Set/Coast: +12V press and hold set.
Accel/Resume: +12V press and hold resume
On/Off:+12V Press On
+12V
No power, voltage drop, or intermittent connection will cause
A bad ground connection: Cruise will not function, loss of
Cruise will not set if this connection is not installed correctly.
Cruise will not resume or accel if this connection is not
Cruise will not set if this connection is not installed correctly.
Cruise will not function if you don't get desired results. If you
get anything but 0 ohms reading you may need to install the
Cruise will not function if you don't get desired results. Your
vehicle may have a faulty brake switch, brake relay or fuse.
- 5 -
Fault Condition
loss of pedal or 'Limp-Mode' condition.
pedal function or 'Limp-Mode' condition.
installed correctly.
brake LED resistor.
Manual #650541
Advertisement
