Intended Use - ABB A170-M66 Operation Manual

Operation Manual / 2 Safety / A100-M axial
1 Safety
1.5

Intended use

Use on internal combustion engines in general
ABB turbochargers are intended for turbocharging internal combustion engines.
To ensure compliance with the machinery directive 2006/42/EC when using on gas engines,
the turbocharger must be operated in an engine room classified as "not at risk of explosion".
This is in accordance with the position paper [2] relating to ATEX issued by EUROMOT [1].
The turbocharger supplies the engine with the air volume or air/gas mixture and the associat-
ed charging pressure required for operation.
The turbocharger is solely intended to be operated with a clockwise direction of rotation as
viewed from the turbine end.
The specific operating limits of the turbocharger were determined on the basis of information
from the enginebuilder about the intended use. These data are given on the rating plate.
ABB accepts no liability and rejects all warranty claims for any non-intended uses.
[1] Euromot = The European Association of Internal Combustion Engine Manufacturers
[2] Directive 94/9/EC concerning equipment and protective systems intended for use in potentially
explosive atmospheres (ATEX) The Euromot Position as of November 2003, ATEX Euromot
Position 191103
Unapproved operation
Any operation of the turbocharger outside of its operating limits can be haz-
ardous to personnel.
WARNING
Only operate the turbocharger within the operating limits.

Only trained personnel must operate the turbocharger.

The intended use of the turbocharger includes compliance with all regulations and conditions.
In particular, the following must be observed:
 Operation Manual
 Instructions of the enginebuilder
© Copyright 2017 ABB. All rights reserved. HZTL4023_EN
Page 5 / 18
Revision C January 2017