Advertisement
Available languages
Available languages
Assembly
This heater is pre-assembled in factory.
Electrical Ratings
This product is rated 12.5 amps (1500W) at 120V, 60 Hz.
Operating Instructtons
1. Before using the heater, make sure that it is on a flat and stable surface. Damage
may occur if it is placed in an incline or decline.
2. Avoid overloading your circuit by not using other high wattage appliances in the
same outlet. At 1500 Watts, this units draws 12.5Amps.
3. Place the heater on a firm, level surface free from obstructions, and at least 3 ft.
(0.9m) away from any wall or combustible material.
Heat Mode Setting
1. To begin heating operation, tun Thermostat control clockwise to the maximum
setting.
2. Turn the power and setting control to your desired heat settings:
1~700W
2~900W
3~1500W
3. The power light will remain illuminated during operation.
Fan Mode Setting
To use the unit as a cooling air circulator without heat, turn the power fan setting
control to
Thermostat Control
1. Turn the thermostat control clockwise to the highest position to start the heater.
Allow the heater to operate and warm up the room.
2. When the desired temperature/comfort level is reached, lower the temperature
setting by turning the Thermostat Control counterclockwise until the heater stops
operating.
3. The thermostat will automatically maintain the pre-set temperature level by
turning the heat ON and OFF.
NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset
temperature. To prevent the unit from cycling, raise the temperature setting.
6
Advertisement
