Advertisement
About the Reader
Proper Use of the Fingerprint Reader
NOTE:
Fingerprint verification performance is dependent upon
how well you enroll your fingerprint.
START POSITION
PROPER FINGER PLACEMENT
Finger is flat to surface and slid with uniform pressure and speed.
Maintenance
While the sensor is very robust do not use excess cleaning
fluids. Use a wet damp cloth for cleaning if needed.
END POSITION
IMPROPER FINGER PLACEMENT
Finger is not flat to surface and /or
speed is inconsistent.
VIDEO IS INCLUDED ON CD.
To see a video on proper finger
movement, please click
HERE.
About the Reader | 1
Make sure you have the following:
Verifi P2000
Fingerprint Reader
1.
Install Reader
Install P2000 for Windows Logon
1.1
WAIT: DO NOT PLUG IN DEVICE YET.
as 32 or 64 bit. If necessary, you may find this information by going to '
Control Panel > System' on your PC to determine your system type. Find the
installation folder on the CD and choose the proper folder 32bit or 64bit.
1.2
Your Windows User Account
Windows will allow biometrics to be used. If you currently do not have a
Windows password, see Control Panel > User Accounts.
Default "Administrator" Account
Windows does not allow the built in administrator user account to
utilize fingerprint biometrics. However, you may use any other user
name with or without administrator privileges with your fingeprint
device. Only the user "administrator" is prohibitied.
Windows 7 or
Verifi CD Installation
Windows 8
Software
Determine your operating system
MUST
be password protected before
1.3
Install the FMA by launching
Setup 2 -
FMA. (Note: The FMA is
used by Windows for managing your
fingerprint enrollments)
1.4
Install the Drivers by launching
Setup 3-
Driver.
1.5
Plug in your fingerprint device
into an available USB port.
Install Reader | 2
Advertisement
