Specifications; Charging The Battery - NINCOAIR NH92013 RTF Manual

WARNINGS:
Radio control models are not toys. Serious injury to people or damage to property can result if not used in a responsible manner.
It is not recommended for children under 14 years old and should only be flown by experienced radio control pilots. It is recommended that this model only be
flown at dedicated radio control flying sites.
Read all instructions carefully prior to assembling and before flying this model. Seek advice should any information be unclear. You assume all risk and
responsibility when using this model.

SPECIFICATIONS:

Wingspan: 1400mm
Battery: Li-Po 11,1v
*****The ARF version does not include transmitter and receiver.
1. TRANSMITTER OPERATION AND FLIGHT CONTROLS.
The transmitter requires 8 AA size alkaline batteries (not included). Fit them into the battery compartment at the rear of the transmitter paying careful attention in
order to observe correct polarity.
Before turning on the transmitter, make sure the throttle stick is pulled all the way back. Switch on the transmitter.

2. CHARGING THE BATTERY

Do not charge the battery more than 120 minutes. Before the first flight, the battery should be circled 3-4 times to 'wake' it up for its best flight performance.
Please, follow the charge instruction that follow in order to charge the flight battery:
Length: 1020mm
Motor/ESC: Brushless
Mode 2
1. Rudder control
2. Throttle control
3. Rudder trim lever
4. Throttle trim lever
Connect to flight
battery
Charging indicator
DC12v power source
NINCOAIR is brand of NINCO DESARROLLOS S.L.
CIF B-60307725 · www.nincoair.com
NH92013 RTF – NH92014 ARF CESSNA 400
Weight: 1240gr
Radio: 2,4 Ghz, 4 Ch, 4 servos
5. Elevator trim lever 9. Servo reverse switches
6. Aileron control 10. On/Off power switch
7. Elevator control 11. Battery indicator
8. Aileron trim lever 12. Power indicator
Charge with wall adapter
Ctra. de l'Hospitalet 32
08940 Cornella Barcelona Spain
4
Charge with car battery
ENGLISH