Table of Contents
Advertisement
Programme end during rinse
hold
– – – 0 appears on the display panel
and the Start/Reload A button
indicator lamp flashes.
To end the programme, set the
programme selector to 0 Spin/
Drain [ or select a spin speed. Then
press the Start/Reload A button.
Programme end
End appears on the display panel and
the Start/Reload A button indicator
lamp is off.
If the N symbol appears on the display
panel, the washing machine has
detected too much foam during the
wash programme and automatically
switched on a rinse cycle to remove the
foam.
Add less detergent for the next
Note:
washing cycle with the same load.
Operating the appliance
Removing laundry/switching
off the appliance
Open the washing machine door
1.
and remove the laundry.
Set the programme selector to off
2.
position. The appliance is switched
off.
Turn off the water tap.
3.
Notes
Do not leave any items of laundry in
■
the drum. They may shrink in the
next wash or discolour another item.
Remove any foreign objects from the
■
drum and the rubber seal – risk of
rusting.
Leave the washing machine door
■
and detergent drawer open so that
any residual water can dry away.
Always wait for the end of the
■
programme, otherwise the appliance
may still be locked. Then switch on
the appliance and wait for it to
unlock.
If the display panel goes off at the
■
end of a programme, energy-saving
mode is active. To activate the panel,
press any button.
en
21
Advertisement
Table of Contents
