Energy Saver Mode - Soleus Air WS1-06E-02 Operating Instructions Manual

USE THE AIR CONDITIONER
Freezing Conditions: This is a cooling only air conditioner. It is not designed for freezing outdoor condi-
tions. It must not be used in freezing outdoor conditions.
Remote Control: To ensure proper operation when using the remote control, aim the remote directly at
the signal receiver on the air conditioner.
The remote control has a signal range up to 20 feet.
•
Make sure nothing is blocking the remote control signal from being received by the air conditioner.
•
Make sure the batteries are installed correctly and still have power.
•
Cooling Mode: Use the Cool mode at High, Medium, Low fan speed when cooling is needed. Use the tem-
perature ▲ or ▼ buttons to set the desired temperature between 61°F-90°F.
Once the temperature is set, the compressor will cycle on and off to keep the room temperature at the set tem-
perature level. The lower the set thermostat temperature, the cooler the room will be. The higher the set ther-
mostat temperature, the warmer the room will become.
For Normal Cooling - set the mode to Cool and the Fan to High or Med with the temperature set to 70
•
degrees.
For Maximum Cooling - set the mode to Cool and the Fan to High with the temperature set to 65 de-
•
grees.
For Quieter & Nighttime Cooling - set the mode to Cool and the Fan to Low with the temperature set to
•
72 degrees.

Energy Saver Mode:

When the Energy Saver mode is ON, the fan will cycle on and off with the compressor. This results in more
variations of room temperature and humidity. Normally, it is used when the room is unoccupied. The fan
may continue to run for a short time after the compressor cycles off.
When the Energy Saver mode is OFF, the fan runs all the time in fan or cool mode.
Fan Only Mode: Use Fan Only mode at High, Medium, or Low fan speed to provide air circulation and
filtering without cooling. Since Fan Only setting does not provide cool, a set temperature cannot be en-
tered. The room temperature will appear in the display.
Loss of Power Protection: If power to the air conditioner is lost or interrupted, the air conditioner will
automatically restart in the setting last used prior to power loss. Timer will be cancelled when power is
lost or interrupted. You may need to set a new timer if desired.
Air Direction: Use the lever on the front air vents to adjust the airflow direction. You can direct the air-
flow to left, right, up or down. The lever is located on the lower left and right side of the air vent.
Auto Mode: The air conditioner will automatically choose Cool or Fan mode based on current room tem-
perature.
Ventilation: In order to maintain the best cooling condition, push the Fresh Air Lever to close the vent.
When fresh air is necessary, pull the Fresh Air Lever to open the vent allowing fresh air being re-
circulated in the room.
Fresh Air Lever
*Fresh Air Lever is unavailable on WS1-06E-02 model.