Wahl Self-Cut Pro Quick Start Manual

WAHL
®
H O M E P R O D U C T S
Keep it Running Like New!
The blades of your
new clipper should be
oiled every few
haircuts. For best
results, place three
drops on front of the
blades and one drop
on each side of blade
as shown. Use only
the Wahl Clipper Oil
included in the pack.
Do not use hair oil,
grease or any oil
mixed with kerosene
or any solvent.
Goof- Proof!
Adding Attachment Guards
Align guard onto blade then press down on
guard where guard number is located until
you hear a snap.
Removing
Attachment Guards
From underneath, lift
tab up to release from
blade.
Blend it!
Use for blending
between different hair
lengths. The taper
lever adds versatility to
your clipper by
allowing you to
gradually change the
closeness of your cut.
(Up position = closest
cut; Down position =
longest cut)
Use brush included to clean out excess hair on clipper and between blades (don't clean with running water)
Quick Start Guide
closest
cut
longest
cut
SAFETY FIRST! Please read instruction book first before using clipper
If defective contact Wahl via 1-800-767-9245
Your New Clipper
Taper
Lever
You can do it!
Section 4: Top of the head
Section 2: Under the rim
of the head
Haircutting Tips & Techniques
When you cut your hair, you should visualize
the head as if it were divided into four
sections. Image above shows the different
sections. Using proper techniques when
moving from one section to the next will help
you blend the sections together for profes-
sional looking results. See instruction book
for more tips.
It's Easy!
Easy step-by-step instructions included.
For more haircutting tips and
techniques visit grooming.wahl.com.
Helpful Hints
Blades
On/Off Switch
Section 3:The rim or side
Section 1: The neckline
©2018
Cord
v. 01.2018
part no: 92365-200