Epson Stylus Photo R260 Supplementary Manual page 6

Epson Stylus Photo R260
Caution: Do not touch the area shown below when you are
changing ink cartridges.
5. Lift up the cartridge cover.
6. Press in the tab on the back of the cartridge and lift the
cartridge out of the printer. Dispose of it carefully.
Warning: Keep ink cartridges out of the reach of children and
don't drink the ink.
If ink gets on your hands, wash them thoroughly with soap and
water. If ink gets in your eyes, flush them immediately with
water. If discomfort or vision problems continue after a thorough
flushing, see a doctor immediately.
7. Unwrap the new ink cartridge.
Caution: Be careful not to break the hooks on the side of the ink
cartridge when you remove it from the package.
Always install an ink cartridge immediately after removing the old
cartridge. If the cartridge is not installed promptly, the print head
may dry out and be unable to print.
Epson Stylus Photo R260
6 -
8. Remove the yellow tape from the bottom of the ink
cartridge.
Caution: You must remove the yellow tape from the cartridge
before you install it; otherwise, print quality may decline or you
may not be able to print.
If you have installed an ink cartridge without removing the yellow
tape, take the cartridge out of the printer, remove the yellow
tape, and then reinstall it.
Do not remove the transparent seal from the bottom of the
cartridge; otherwise, the cartridge may become unusable.
Do not remove or tear the label on the cartridge; otherwise, ink
will leak.
9. Lower the cartridge into the holder, with the green circuit
board facing the front. Then gently push the cartridge down
until it clicks into place.
10. If you need to replace another ink cartridge, repeat steps 6
through 9 before continuing with step 11.
9/06