Table of Contents
Advertisement
RUGGEDCOM WIN7258
Installation Guide
1.
Liberally apply an anti-corrosion spray to all galvanized steel components, including mounting brackets,
washers and screws.
2.
Select a mounting location on the wall.
3.
Align the mounting bracket with the selected mounting location on the wall/tower.
4.
Mark the location of the mounting holes on the wall/tower.
5.
Remove the mounting bracket from the wall/tower.
6.
Using a 8 mm (5/16 in) drill bit suitable for the building material, drill holes at the marked locations.
7.
Insert a 8 mm (5/16 in) wall anchor into each mounting hole.
8.
Attach the base station to the mounting bracket. For more information, refer to
the Base Station and Mounting
CAUTION!
Environmental hazard – risk of damage due to the ingress of water, dirt or debris. Make sure the
base station is oriented with the interface connections facing down.
9.
Place the base station and mounting bracket assembly against the wall/tower and align it with the pre-drilled
holes.
Figure 3: Mounting the Base Station to a Wall or Tower
1. 8 mm (5/16 in) screws 2. Spring Washer 3. Flat Washer 4. Wall Anchor
10. Secure the mounting bracket to the wall/tower using the appropriate 8 mm (5/16 in) screws, spring washers
and flat washers.
11. Liberally apply an anti-corrosion spray to all exposed screw threads.
Section 2.5.2
Mounting the Base Station to a Pole
The base station can be attached to any pole (or pipe) with a 44.45 to 254 mm (1.75 to 10 in) diameter.
To mount the base station to a pole, do the following:
Mounting the Base Station to a Pole
Bracket".
Installing the Base Station
Section 2.5.3, "Assembling
2
3
1
4
Chapter 2
11
Advertisement
Table of Contents
