How to use
• Apply the oil to the blade before and after each use.
(See page 14.)
• The appliance may not operate in an ambient
temperature lower than approximately 0 °C.
• Please clean the appliance after each use.
(See pages 12 and 13.)
<Note before trimming>
• Make sure that the main body is turned off.
• Check that the blades are not damaged or deformed
before use.
• Do not use with shaving foam applied or when the
beard is wet.
A wet beard may stick to the skin or bunch up, making
it difficult to trim.
• Before trimming, comb your moustache with a comb.
1
Remove the protective cap. (See this page.)
2
Select the desired attachments, then press the
power switch to turn on the power and trim.
• Use the appropriate attachment as needed.
It can also be used without the attachment.
● Without the attachment (See page 11.)
● Trimming height comb attachment (See page 11.)
● Detail trimming attachment
(See page 12.)
3
Turn off the power switch after use.
10
PB017539 - ER-GD30 20
_(01GB)_04-04-19.indd 10
Removing and mounting the attachments
• Take care not to injure hands, etc., with the blade
when removing or mounting the attachment.
►
Hold the main body
securely and pull the
attachment out upward
and remove it from the
main body.
• Hold the rib (
securely and remove
the detail trimming
attachment.
►
Mount the attachment to
the main body until it
clicks.
• If the attachment is not
attached correctly, it
may shift and end up
cutting too much during
use.
ER-GD30
• You can follow the same procedure to remove
and mount the protective cap.
Removing the attachment
) part
a
Mounting the attachment
a
ER-GD30
Click
ER-GD30
2019/4/4 10:52:42