Changing The Blade - Promaker PRO-SC1500 User Manual

PARALLEL CUT
FIG 7
• Adjust the parallel guide to the
desired width from the blade, then
tighten the retaining screw (fig 7, fig
8).
Caution: Make sure that the plain
witch parallel guide against should
be parallel with cutting line marked
on work piece to be cut.
CUTTING DEPTH ADJUSMENT
FIG 9
• Loosen the cutting depth lever.
• Hold the base plate flat against the
edge of the work piece and lift the
body of the tool until the blade is at
right depth.
• Tighten the depth locking lever (fig
9, fig 10).
FIG 8
FIG 10
O- 45º MITRE CUT
FIG 11
• Loosen the 0º - 45º locking knob
(fig 11, fig 12).
• Tilt the body of saw until the
required angle is reached.
• Tighten the locking knob to secure
the base plate.

CHANGING THE BLADE

When the blade is worn out, it should
be changed as the procedure in
BLADE INSTALLATION.
WARNING! Do not attempt to cut
pieces too small. Avoid awkward
hand positions where a sudden slip
could cause your hand or finger to
come in contact with de diamond
blade. When cutting any material,
make sure that it is fully supported.
Hold work piece firmly. DO NOT
FORCE THE TOOL IN CUTTING
THE WORK PIECE.
MAINTENANCE
CAUTION for your safety, turn off
switch and unplug saw from the
power source before performing
any maintenance or cleaning. If the
power cord become damaged in
any way, replace it immediately with
FIG 12
10