Related Manuals for UHP NETWORKS Romantis UHP-100
Summary of Contents for UHP NETWORKS Romantis UHP-100
- Page 1 HIGH-THROUGHPUT SATELLITE ROUTER UHP-100 Romantis UHP-100 Manual GENERAL DESCRIPTION AND INSTALLATION GUIDE DOCUMENT RELEASE 3.2 [UHP.10032.EN] JANUARY 2016...
-
Page 2: Table Of Contents
Local access to router via HTTP interface ................13 2.2.6 Local access via USB ........................ 13 2.2.7 Remote Telnet access ......................14 2.2.8 Command Interface ........................ 14 Operations .......................... 15 Software updates ........................15 © UHP NETWORKS INC 2016 www.uhp.net... - Page 3 Figure 6 Satellite Router UHP-100 series - front view ................10 Figure 7 Standard interconnection of the router ..................13 Figure 8 Router resetting to default procedure ..................17 TABLES Table 1 Operational limits ........................... 12 Table 2 Troubleshooting guide ........................16 © UHP NETWORKS INC 2016 www.uhp.net...
-
Page 4: Acronyms And Abbreviations
(the carrier wave). RF level Absolute RF level of entire signal (carrier + adjacent carriers) expressed in dBm. Reed–Solomon error correction is an error-correcting code that works by oversampling a polynomial constructed from the data. © UHP NETWORKS INC 2016 www.uhp.net... - Page 5 IP networks such as the Internet or other packet-switched networks. VSAT Very Small Aperture Terminal – satellite earth station with small-size antenna Weighted fair queuing. Method of proportional division of bandwidth between transmission queues. X-modem Simple file-transfer protocol © UHP NETWORKS INC 2016 www.uhp.net...
-
Page 6: Introduction
Copyright The content of this document is the intellectual property of UHP Networks Inc. (referred to below as Romantis). Copying or quoting this description as a whole or of any part of it without a written permission from Romantis is prohibited. -
Page 7: General Description
The warranty seals are located on the bottom of the product, at the junction of the two parts of the case. Product warranty will automatically void if such labels have been removed, modified or damaged. © UHP NETWORKS INC 2016 www.uhp.net... -
Page 8: Packaging And Content
It is recommended to keep original packaging throughout the entire lifetime. Conservation, storage and transportation of the terminal must be in original packaging. Description and principles of operation UHP-100 Ethernet Switch Figure 4 UHP-100 router structure © UHP NETWORKS INC 2016 www.uhp.net... -
Page 9: Overview
PROHIBITED UHP-100 modulator is compatible with most satellite transmitters/converters (BUC). Those incompatible are only transmitters that require to explicit “TX On” FSK command but such transmitters are extremely rare and are not widely employed. © UHP NETWORKS INC 2016 www.uhp.net... -
Page 10: Reset Button
2 – Router cannot receive TDMA configuration from the HUB (TDM/TDMA network mode). The reason can be in the non-availability of receive channel from the HUB, CRC errors during reception, wrong configuration of the Terminal. © UHP NETWORKS INC 2016 www.uhp.net... -
Page 11: Lock" Indicator
“RX2” indicator flashes every time a data placket is received via RX2 interface. 1.5.14 “TX” Indicator “TX” indicator flashes every time a data placket is transmitted, including a blank packet (if no data is available for transmission). © UHP NETWORKS INC 2016 www.uhp.net... -
Page 12: Operations
Typically, the router UHP-100 is connected to individual RF frequency equipment (ODU). In such configuration the TX output of the modulator is connected to the BUC. The router will supply the BUC with 24V power and 10MHz © UHP NETWORKS INC 2016 www.uhp.net... -
Page 13: Powering On
Device Manager. If it is appeared you can start working with the router. When working with the port from the terminal program the data rate and control parameters can be set to any value since they are ignored. © UHP NETWORKS INC 2016 www.uhp.net... -
Page 14: Remote Telnet Access
Please refer to the Command Interface manual applicable for the respective version of SW and activated mode of operation of the UHP router. The Command Interface manuals are available for download and online use on Romantis website: http://www.uhp.net. © UHP NETWORKS INC 2016 www.uhp.net... -
Page 15: Operations
Servicing by qualified personnel only; Actions in case of fire In case of fire or any smoke of the router please immediately power off the device and if necessary, use extinguishing tools that are intended for electrical circuits. © UHP NETWORKS INC 2016 www.uhp.net... -
Page 16: Troubleshooting
Station is not Wrong network setting Check Tx frequency and symbol rate of the transmitting modulator. Make sure that transmission is enabled (Reception is normal: Transmission of the terminal is not Contact Hub administrator © UHP NETWORKS INC 2016 www.uhp.net... -
Page 17: Resetting To Default Settings
After the first saving of the configuration the ERROR and SYSTEM indicators stop flashing simultaneously. © UHP NETWORKS INC 2016 www.uhp.net... -
Page 18: Storage, Transportation And Disposal
- limiting high temperature of storage (50 ± 2) ° C. - atmospheric pressure 720 ÷ 770 mm. Hg. Utilization of satellite routers must be in accordance with the rules for disposal of industrial or consumer electronics in accordance with applicable law. © UHP NETWORKS INC 2016 www.uhp.net...
Need help?
Do you have a question about the Romantis UHP-100 and is the answer not in the manual?
Questions and answers