JVC HR-S7955EK Instructions Manual page 13

et
TV
TV/VCR AUDIO – –:– –
1 2 3
., /
ABC DEF
2
4 5 6
GHI JKL MNO
VPS/PDC DAILY/QTDN. WEEKLY/HEBDO
7 8 9
PQRS TUV WXYZ
0000 AUX 4
0
START STOP
DATE PR
DEBUT FIN
EXPRESS
?
1 PROG 30 SEC
LP00000-000
VCR/TV
All manuals and user guides at all-guides.com
Check the Results
When or
Auto Setup Preset Download
following examples on the VCR display panel:
The Preset Positions and the Clock have been set successfully
Go straight to
The Preset Positions have been set successfully but the Clock has not
Perform Clock Set on page 66.
Go to Step 3
Neither the Preset Positions or the Clock have been set successfully
Make sure the cables are connected properly to the VCR and turn
the VCR off and then on again. Try
again.
Finish Off
Select the Video channel or AV mode, then make sure that all necessary stations
have been stored in the VCR's memory by using the PR + or - buttons.
If station names (ID —
station name will be displayed at the top left corner of the TV screen for about 5
seconds each time you select a different channel via the VCR.
You can now use it to play and record.
The VCR is now set up.
IMPORTANT
• re-running setup Auto Setup or Preset Download may not behave as
described if it has already been run on the VCR. This is because some of the
information gathered on the first Auto Setup or Preset Download is retained in
memory and that part of the process may be skipped by the VCR.
• bad reception In certain reception conditions, station names may not be
stored correctly, and Guide Program Numbers
happens, when you timer-record a TV programme using the VIDEO Plus+
system, the VCR will record a TV programme of a different station. When
programming the timer using the VIDEO Plus+ system, be sure to check that
the preset position corresponding to the broadcasting station you wish to
record has been selected (
• duplicate stations You may be able to receive the same station from two
different transmitters in which case Auto Setup will detect and store both. It is
normal for one transmitter to give you a better quality picture than the other; to
delete those stations which have a poor picture
• manual station setting If any of the above problems occur, refer to
pages 62 – 63 to input station names (
change station preset positions (
• rf connections In certain reception conditions, the Video Channel may not
be set correctly and interference may appear in the TV picture while the VCR's
power is on. Set your Video Channel manually. (
IF YOU HAVE ANY DIFFICULTY WITH THE ABOVE PROCEDURES CALL THE JVC
CUSTOMER SERVICE HOT LINE ON 0870 330 5000
three step quick start
finishes, you will see one of the three
(20:00 used as example only).
Step 3
.
Auto Set Up
pg. 64) have also been stored in the VCR's memory, the
may not be set properly. If this
pg. 23, VIDEO Plus+ Timer Programming
Change Station Name
Change Station Preset Position
or
Preset Download
).
on page 62.
Delete A Channel
). You can also
).
pg. 59,
Video Channel Set
13
)