Advertisement
Removing Collected Water (cont.)
NOTE: The pump may cause big noise when it starts to work for 3~5 minutes. It is a normal phenomenon.
NOTE: The pump operation on light blinks at 1Hz when the pump is operational failure. Please turn o
the unit and plug the power cord out. Check the following things: Cleaning the lter of the pump.
-Remove the bucket from the unit, take down the pump and clean the lter of the pump.
-Check that the pump drain hose does not link or block.
-Empty the water of the bucket.
-Reinstall the pump hose if it drops and reinstall the bucket properly. Turn on the unit. If the error
repeats, call for service.
Filter of the pump
NOTE:
-Make sure the connection is tight and there is no leak.
-Lead the water hose to the oor drain or a suitable drainage facility, the drainage facility and the
water hose should be lower than the drain outlet of the unit.
-Be sure to run the water hose sloping downward to let the water ow out smoothly.
-When the continuous drain feature is not being used, remove the drain hose from the outlet.
NOTE
Do not use this operation when the outdoor temperature is
equal to or less than 32°F (0°C), otherwise water may freeze
causing blockages and the unit may cease to function properly.
Make sure to empty the bucket at least once a week when
using the pump draining feature. When the pump draining
feature is not being used, remove the pump drain hose from
the outlet. Press the pump drain hose outlet in and take the
pump drain hose out from it . Make sure do not let the water in
the pump hose drip to the oor.
User Manual
Press the power cord
buckle into the rear
cover.
1,Press the pump drain
hose outlet in
2,Take the pump
drain hose out
Page 11
Hide quick links:
Advertisement
