Resetting The Ethernet Card; Installing Ink Cartridges For The First Time - Epson Stylus Color 850Ne Specifications

EPSON Stylus COLOR 850Ne

Resetting the Ethernet Card

When the Ethernet card's status lights show an error
condition, you may be able to correct it by resetting the
printer memory. Press the
on the card go out, press the button again.
Installing Ink Cartridges for the
First Time
Always use the ink cartridges that came in the box the first
time you set up the printer. Follow these steps to install the
ink cartridges:
1. Make sure the printer is turned off (the
should be up). Then plug the printer's power cord into a
grounded outlet.
Caution:
Always use the power button to turn the printer on or off. Never
P
use an external switch—such as a power strip switch—to turn off
the printer.
Don't use an outlet that can be turned off by a wall switch or timer,
or one that uses the same circuit as a large appliance. This may
disrupt the power, which can erase memory or even damage the
printer's power supply.
2. Remove the ink cartridges from their foil packages. Then
remove only the yellow part of the tape seal on the top of
each one. Don't pull off the white portion or try to remove
the clear seal underneath the cartridge.
8 - EPSON Stylus COLOR 850Ne
power button. After the lights
P
power
button
power button
P
black cartridge
Caution:
To ensure the print heads charge correctly, install the ink cartridges
that came with the printer.
You must remove the yellow tape from the top of the cartridge or
you will permanently damage it. It's OK if a small corner of the
yellow tape stays on the cartridge.
Warning:
If ink gets on your hands, wash them thoroughly with soap and
water. If ink gets in your eyes, flush them immediately with water.
3. Press the power button to turn on the printer. The
P
power light flashes and the
P
lights come on. The black ink cartridge holder moves into
loading position.
4. Open the printer cover and lift up the black ink cartridge
clamp.
5. Place the black ink cartridge in the holder with the label
pointing up and the arrow pointing to the back of the
printer. Then close the clamp, making sure it clicks into
place.
10/98
Remove the yellow
tape seal, but
don't remove the
white portion
color cartridge
black and
B A
black ink cartridge
holder
color ink out