Velleman DVR4MQA Manual page 13

i) MOTION
Press the MENU button and press ▲or ▼to select 'MOTION' (cf. figure on the right).
Press ENTER to enter the motion menu. A screen as shown below will be displayed.
1) SEN (Sensitivity)
Set the sensitivity of the pixel-based motion detection feature from 1 (high) to 99 (low sensitivity). Default value is 70.
2) MD-NUM (Motion Detection Number)
Set the number of targets in which motion must occur for the alarm to be triggered (from 1 to 99 – cannot be more
than the number of targets set under AREA).
3) RE (Reference)
Set the reference image to which the current screen is compared (1-99). For example, value 64 would compare the
current image to the 64
4) DET (Detection)
The motion detection on each channel can be turned ON or OFF individually.
5) AREA
Press the ENTER button when this option is selected to set the pixel-based motion detection area for each channel.
Green targets represent the motion detection area and purple targets represent detected motion.
Use these controls to modify the motion detection area (see figures p.5):
▲▼►◄: navigates between targets, ZOOM turns selected target ON/OFF
'-' turns all targets on the screen ON/OFF ; '+' turns all targets on the selected row ON/OFF
NOTE: when DET is ON, you must set a motion detection area or there will be no triggering.
The red block indicates on which field you are positioned ; the green area indicate which fields are set to ON.
Upon a motion detection, the affected fields turn purple ; after ALARM DURATION, the original settings are restored.
DVR4MQA
SEN ND-NUM RE
CAM1 70
CAM2 70
CAM3 70
CAM4 70
MOTION RECORD: ON
DAY
DAILY 00:00
image before that. A higher value may increase the sensitivity.
th
(MOTION)
DET
03 64 ON AREA
03 64 OFF AREA
03 64 ON AREA
03 64 ON AREA
START END
00:00
- 13 -
(MENU)
TIMER
CAMERA
RECORD
ALARM
DWELL
PIP
MOTION
DISPLAY
REMOTE
USER
SYSTEM
EVENT
VELLEMAN