Page 1
’ ’ USER MANUAL USER MANUAL PLEASE DO NOT RETURN PRODUCT TO THE STORE. If you have any problem or concerns, please feel free to contact our customer service department. We will reply you as soon as possible. E-Mail: csr@merax.com TELTEL: 9095901000 rma@livingess.com Tel: 626-912-8886 Ext.100...
1. Product Brief Product name: Single function Motorized Treadmill Main parameters and parts list Parameters Names Description Input power voltage 110V~ Rated frequency 50-60Hz Rated power 1.5HP Speed 0.8-12km/h Running surface 15.8*43.3 inch Max user weight 240LBS Expand dimensions 52*24*40 inch Packing list Name Units...
2. Security Precautions and Warnings Tip: Before folding the treadmill, make sure that the surface incline is "zero". Please read the instructions carefully before use. Notice: This treadmill is for indoor use and storage only. Avoid spilling water on it or placing it in damp areas.
Page 5
---- Otherwise an accident or injury may occur. Don't jump up and down while the treadmill is in motion. ---- Injuries may result from falling. Don't keep machine in or near moist/damp space such as thebathroom. Don’t place machine in direct sunlight, or high temperature places such as near a stove or a heating appliance.
Page 6
Don’t use the treadmill when the power plug is on or near the needle, garbage, or water. ----May cause electric shock, short circuit, or fire. Do not touch the power plug with wet hands! When not in use, pull out the power plug from the socket. ----Surrounding dust and moisture can age the insulation, and result in a possible leakage fire.
3. Installation Instructions When installing, simple arrange all of the screws in their proper position first, then tighten the screws the treadmill frame has been positioned when the installation of frame is done. Name Complete Machine 6mm inner hexagon wrench 5mm inner hexagon wrench Combination wrench Safety key...
Page 8
1. Put the machine flat on the ground. Raise the supportive columns and console upward in the direction shown by the arrows in the picture below. 1. Use a #5 hexagon wrench and screw provided screws (M6*12) to secure the treadmill base (use two M6*12 screws for each side).
Page 9
4. Put the safety key on the yellow circle on the console, as seen in the picture below. Press the start button to start the treadmill. (Notice: The treadmill only starts when the safety key is attached to the yellow circle on the console.) Safety key is in red color.
4. Using Instructions Using your treadmill 1) Insert the power plug properly and turn on the switch(in red color) When the light is on, you will hear beep sound, and then the screen will light up. 2) Safety key Introduction The treadmill can only start when the safety key is put on the yellow area of the display console.
Page 11
4) Button function Start button/Stop When the power is on, press the start button and the screen will display “0.8 km/h”, and the treadmill will start. When you are running on the treadmill and press the stop button, all of the data on the screen will clear and the treadmill will gradually come to a complete stop and return to manual mode.
Page 12
7. Automatic program Each program is divided into 10 segments, and the running time of each segment of the program is evenly distributed. Following is a form of speed distribution of 12 programs. Time Set time/ 10 = Running time of each segment Program Speed Speed...
Error Code Meaning Error code Error Description Error handling Possible Causes: The electronic connection between the console and lower controller is blocked, check each Disrupted Electronic wire that connects the console with the lower controller, Connection: When turned on, make sure that each wire base is fully plugged in. the connection between the Check the cable of the console and lower controller, lower controller and the...
Page 14
5. Routine Maintenance Warning: Before cleaning or doing product maintenance, please ensure the treadmill power plug is pulled out of the electric socket. Cleaning: Thoroughly cleaning your treadmill will extend its usage life. Remove dust periodically in order to keep the parts clean. Be sure to clean both sides of running belt, this will reduce the accumulation of dust and dirt.
Page 15
Picture A Picture B Applying silicone oil Step 1: Open up the treadmill belt Step 2: Open the silicone oil bottle, squeeze the silicone oil to both sides of the running board, as in the picture bellow:...
Need help?
Do you have a question about the 005-524 and is the answer not in the manual?
Questions and answers