Table of Contents
Advertisement
EN
Features
LED Indicator
Operation
1. Ensure the power supply is off and disconnected from the wall outlet.
2. Connect your device to the power supply's DC output port.
3. Connect the power supply to the AC wall outlet.
4. Turn on the power supply.
5. Turn the power supply off before connecting other devices or disconnecting
the power supply from the AC wall outlet.
6. Remove all output connections after use. Disconnect the power supply from
the AC wall outlet.
CAUTION: Only use the power supply in a well-ventilated area that is cool
and free from moisture. Do not block the cooling fan or the power supply
may overheat and shut off. Overheating may result in damage to the power supply.
Overload/Error Indication
In case of an error or overload, the LED will turn red.
The power supply is capable of handling up to 380 Watts output. Verify that the
equipment plugged into the outlet does not exceed the power rating. The power
supply's overload protection circuit will automatically shut down the power
supply when it is overloaded and will reset by turning the POWER to OFF. If the
overload protection circuit is engaged, use a device with a lower power output
before powering ON the power supply again.
If the connected device does not exceed the power supply's 380 Watts output
and the overload LED is red continuously, an internal fault may have occurred.
Contact the Horizon Hobby Service Center immediately.
4
Cooling Fan
DC Output
AC Power Input Socket
Power Switch
Advertisement
Table of Contents
