Od-100 Assembly - Cal Spas Saunas Owner's Manual

28

OD-100 Assembly

Remove the packaging panel marked "OPEN THIS END" first to access the contents. Once the panel is
removed, unscrew the cross-member support from inside the crate. Remove the contents from the crate and
assemble in a place with adequate room.
Tools required:
The assembly of this sauna will require at least three people. The panels, roof top and roof assembly are heavy
and difficult to lift by only one person.
1. Assemble the bench. Screw the legs into the underside cross-support of the bench. After assembling the
bench, place the bench on the wooden flooring of the sauna.
2. Place the heater bottom support on the front left corner and the place the heater on top of the heater
support.
3. Place the wall panels against the flooring and attach the panels (with the provided screws) to the flooring.
Attach the center pieces and place between the two front and two back panels. Then place the corner piece
and attach it to the wall panels.
Repeat these steps, as necessary, to complete the wall assembly.
Portable drill, screw driver, rubber mallet
2009 Saunas
LTR20091007, Rev. A