Bosch WTX87MF0CH Installation And Operating Instructions Manual page 40

Cleaning and maintenance
en
Remove all of the fluff from the heat
4.
exchanger cover and remove the
fluff filter.
Ensure that no dirt remains on
Note:
the seals of the heat exchanger
cover.
Rinse the inside of the heat
5.
exchanger cover and the fluff filter
thoroughly under running water and
dry them.
Notes
– You can use a soft brush to clean
off more stubborn dirt.
– Make sure you dry the fluff
collector's filter thoroughly after
rinsing it. If the fluff filter is damp,
this may increase the drying time
and affect the drying result.
Pull the fluff collector out horizontally.
6.
The fluff collector may contain
Note:
fluff and residual water, which may
drip out of it when you pull it out.
40
Open the fluff collector and remove
7.
any fluff.
Rinse the fluff collector's filter
8.
thoroughly under running water and
dry it.
Notes
– You can use a soft brush to clean
off more stubborn dirt.
– You must not remove or damage
the fluff collector's seal.
– You can also clean the fluff
collector in the dishwasher.
– Make sure you dry the fluff
collector's filter thoroughly after
rinsing it.
Close the fluff collector.
9.
Ensure that you close the fluff
Note:
collector fully.