Table of Contents
Advertisement
ð
õ
ó
'§"
•©£
--------
Empty the condensa-
tion container
~ Page 31
Base unit
Automatic heat
exchanger rinse
Basic appliance care
programme
CoolDown
Empty the condensation container and then rein-
■
sert it.~ Page 31
Then press A (Start/Reload).
Clean the filter in the condensation container.
■
If the optional drain hose* is installed, make sure
■
that the drain hose:
– Is correctly connected. ~ Page 36
– Is not kinked or bent.
– Is not blocked or clogged, e.g. by deposits.
Run the intensive appliance care programme.
■
Check that no debris has found its way into the base
■
unit. Open the maintenance flap and remove any
debris.
Cleaning the base unit ~ Page 39
The heat exchanger is being cleaned automatically. Do
not pull out the condensation container or cancel the
programme while this is displayed.
Not a fault. After a certain period, the appliance will
automatically recommend that you run the basic appli-
ance care programme. Run the basic appliance care
programme. ~ Page 45
The appliance can reach high temperatures when dry-
ing. To cool the laundry, the CoolDown process reduces
the temperature in the drum. If the door is not opened,
the CoolDown process automatically starts after
30 seconds in the following cases:
Pause the programme
■
Cancel the programme
■
You can continue to operate the appliance during the
CoolDown process.
Notes
The drum continues to rotate during the CoolDown
■
process, even if you have paused the programme.
Do not change the programme during the
■
CoolDown process.
Temperature regulation can take up to 10 minutes.
■
Display
en
23
Advertisement
Table of Contents
