Select Blade Cone; Assembly And Operation - Silvercrest SSE 80 A1 Operating Instructions Manual

6.2 Select blade cone

Which blade cone A/B/C 6 is most suitable depends on the properties of the food, and
in particular its firmness. The following table contains some examples for orientation. The
firmness may vary depending on variety and ripeness, however.
Vegetables/fruit
Apple
Pear
Potato
Kohlrabi
Carrot
Cucumber
Sweet potato
Radish
Beetroot
Courgette

6.3 Assembly and Operation

1. Place the bowl 12 into the base 10.
2. Remove the desired blade cone A/B/C 6
from the blade store 11 and place it
onto the cone holder 4.
3. Figure A: grip the cone holder 4 firm-
ly and rotate the blade cone 6 anti-
clockwise until it stops.
4. Figure B: place the filler chute 2 with
the assembled blade cone 6 into the
holder 8 of the base 10. The arrow
3
symbol 3 must point to the open
lock symbol 7.
Turn the filler chute 2 anticlockwise un-
3
til the arrow symbol
the closed lock symbol
chute 2 audibly and palpably clicks
into place.
8
GB
Blade cone A Blade cone B
Tagliatelle
(approx. 9 mm) (approx. 5 mm)
5. Spear your vegetable or fruit firmly on
6. Connect the mains plug 13 with the
7. Switch on the device using the on/off
8. Start the spiral cutting of the food by
3 is pointing at
7. The filler
9. Switch off the device using the on/off
Blade cone C
Linguine Spaghetti
(approx. 3 mm)
not suitable
not suitable
not suitable
the plunger 1 and then place the
plunger 1 complete with the food into
the filler chute 2 as vertically as possi-
ble. In this way you will obtain nice
long "noodles".
wall socket.
button I/ 9 (I). The LED in the button
is lit.
carefully pressing down the plunger 1.
For continuous spirals, apply consistent
pressure; to obtain shorter "noodles",
occasionally interrupt the pressure.
button I/ 9 ( ). The LED in the but-
ton goes out.