Load Ink - Epson Stylus C60 Start Here

3
3
Power On
1
Plug the printer into a grounded electrical outlet.
2
Press the power button to turn on the printer.
Don't turn on your computer yet.
Don't use an outlet controlled by a wall switch or timer. Never use a power strip switch
to turn the printer on or off; use only the printer's
4
4

Load Ink

1
Open the output tray and raise the printer cover.
2
Lift up the ink cartridge clamps.
You must install both cartridges or the printer won't work.
3
Unpack the ink cartridges that came with your printer and remove the yellow tape.
4
Tilt each cartridge toward you as you lower it. Make sure the tabs rest on the hooks.
black
hooks
5
Lower the clamps so they snap shut.
6 Press the ink replacement button and close the printer cover. You see the
green power light flash and you hear the printer make noise.
ink replacement
button
Don't turn off the printer or interrupt ink charging while the
flashing or you'll use up more ink than necessary when you turn it back on.
7
Wait until ink charging is finished (the green
power button.
Don't remove the seals from the
bottom of the cartridges; ink will
leak out.
Keep cartridges out of the reach
of children.
Don't place the cartridge tabs
color
under the hooks, or you may
damage the clamp when you
close it.
power light stops flashing).
Turn over
power button
2
1
power light is