Wiper Service Mode; Front & Rear Windshield Wipers & Washers; Front & Rear Windshield Wipers & Washers / Lifting Wipers/Wiper Service Mode - Kia TELLURIDE Features & Functions Manual

STEERING WHEEL CONTROLS
Front & Rear Windshield Wipers & Washers
To operate front wipers & washers:
Move lever up/down to change wiper modes
§
MIST: Single wipe
OFF: Wiper off
INT*/AUTO*: Intermittent*/Auto Rain Sensing*
Pull to spray and wipe
§
To operate rear wipers & washers:
Rotate Rear Wiper switch to change Wiper modes
§
Push lever to spray and wipe
§
Auto Rain Sensing*
The rain sensor located on the upper end of the windshield glass
is designed to sense the amount of rainfall and control the wiping
cycle for the proper interval. The more it rains, the faster the wiper
operates. When the rain stops, the wiper stops.
To turn ON the auto rain sensing wipers, move lever up/down to AUTO. To adjust the auto rain sensing
wiper speed setting, move the speed control switch
QUICK TIPS
§ When the Engine Start/Stop button is in the ON position and the wiper switch is in AUTO mode, the wiper will automatically
operate once to perform a self-check of the system
Set the wiper to the OFF position when the wiper is not in use
§
§ Moving lever to HI increases intermittent wipe frequency and wipe speed. Moving lever to LO decreases frequency of wipes
§ Pressing button up increases Intermittent wipe frequency and wipe speed. Pressing button
A
On Rear Wipers, intermittent wipe function is not adjustable
§
See section 4 in the Owner's Manual for more information.
Lifting Wipers (Wiper Service Mode)
To lift the windshield wipers to clean the windshield, inspect or replace wiper
blades or raise the wipers in snow/ice conditions without damaging the hood,
the blades need to be moved to the service position
With the ignition ON, turn the ignition OFF, and within 20 seconds move the
wiper switch up to the MIST position
two seconds until the wiper blade is in the fully up position.
To return wipers to the normal position, turn the ignition ON, then activate MIST.
C
ALWAYS CHECK THE OWNER'S MANUAL FOR COMPLETE
OPERATING INFORMATION AND SAFETY WARNINGS.
LO: Slow wipe
HI: Fast wipe
A
.
C
and hold the switch for more than
B
Image for illustrative purposes only.
See section 7 in the Owner's Manual for more
information.
B
A
MIST: Single wipe
OFF: Wiper off
INT*/AUTO: Intermittent*/Auto Rain Sensing*
LO: Slow wipe
HI: Fast wipe
up/down.
down decreases frequency of wipes
A
*IF EQUIPPED
QR CODE
WIPER SERVICE
MODE VIDEO
To view a video on your
mobile device, snap this
QR Code or visit the listed
website. Refer to page 2
for more information.
www.youtube.com/KiaFeatureVideos
39