Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for kincrome K12085
Summary of Contents for kincrome K12085
- Page 1 HYDRAULIC PIPE BENDER Distributed by Kincrome Group www.kincromegroup.com...
- Page 2 Using the Pipe Bender ......................4 Warning..........................5 MAINTENANCE AND STORAGE...................5 Important Note: ........................5 Adding Oil:...........................5 Replacing Oil:........................5 Cleaning ..........................6 Storage..........................6 Repairing Pipe bender ......................6 WARNING...........................6 SPECIFICATIONS Working Load limit 12000 KG Bending Dies 1/2” to 2” Total Weight: 38 KG Part Number K12085...
- Page 3 IMPORTANT SAFETY INFORMATION The use of a Hydraulic Pipe Bender has inherent dangers to avoid risk of personal injury or property damage make sure you are fully aware of the operating instructions for this product, the recommendations in this manual can not cover all eventualities this tool is designed and intended for use by properly trained and experienced personnel.
- Page 4 OPERATING HYDRAULIC PIPE BENDER Preparing Work Area Before using the pipe bender, it is important to prepare work area properly. Follow this procedure each time the pipe bender is used to help prevent property damage and or serious injury. 1.) Thoroughly inspect pipe bender for damage or wear before each use. Briefly test operation of unloaded hydraulic ram before using to bend any job.
- Page 5 3.) Adjust the guide rollers to the desired distance to achieve the angle of bend required. 4.) Inset the pipe into pipe bender – for large diameter or long lengths of pipe two people are required one to balance the pipe and the other to operate the pipe bender 5.) Twist jack handle completely clockwise on the release valve.
- Page 6 Cleaning Hydraulic ram should be wiped clean with soft cloth only. Do not use gasoline, kerosene, or other such solvents or any abrasive cleanser as cleaning agents and solvents will cause deterioration of the hydraulic seals. Storage Before storage, twist handle 1-1/2 turns counterclockwise to release pressure in hydraulic cylinder. Leave valve in this position.
- Page 7 Item Description Item Description Item Description Frame 1/2” bending die Jack handle 12 Ton Ram 3/4” bending die Spring Plate Hex bolt 1” bending die Spring Roller shaft 1-1/4” bending die Eye bolt Guide roller 1-1/2” bending die Hitch pin 2”...
- Page 8 Distributed by Kincrome Group www.kincromegroup.com 3 Lakeview Drive Scoresby Victoria Phone: 1300 657 528...
Need help?
Do you have a question about the K12085 and is the answer not in the manual?
Questions and answers