Table of Contents
Advertisement
Quick Links
PLBS-S
Receiving instructions:
After delivery, IMMEDIATELY remove the packaging from the carpet pole in a manner that preserves the
packaging and maintains the orientation of the product in the packaging; then inspect the product closely
to determine whether it sustained damage during transport. If damage is discovered during the
inspection, immediately record a complete description of the damage on the bill of lading. If the
product is undamaged, discard the packaging.
NOTES:
1) Compliance with laws, regulations, codes, and non-voluntary standards enforced in the location where
the product is used is exclusively the responsibility of the owner/end-user.
2) VESTIL is not liable for any injury or property damage that occurs as a consequence of failing to apply either:
a) Instructions in this manual; or b) information provided on labels affixed to the product.
Table of Contents:
Hazard Identification: Explanation of Signal Words....................................................................................... 2
Safety Recommendations........................................................................................................................ 2
Product Specifications............................................................................................................................. 2
FIG. 1: PLB/S exploded parts diagram & bill of materials................................................................................ 3
Use instructions.................................................................................................................................. ... 3
Inspections.......................................................................................................................................... 3
Maintenance......................................................................................................................................... 4
Label Placement Diagram........................................................................................................................ 4
Limited Warranty.................................................................................................................................... 5
Copyright 2014 Vestil Manufacturing Corp.
Rev. 4/17/2015
V
2999 North Wayne Street, P.O. Box 507, Angola, IN 46703
Telephone: (260) 665-7586 -or- Toll Free (800) 348-0868
www.vestilmfg.com
W
ERIES
HEELED
I
NSTRUCTION
M
ESTIL
ANUFACTURING
Fax: (260) 665-1339
e-mail:
, S
P
TEEL
M
ANUAL
PLBS, MANUAL.doc
C
.
ORP
sales@vestil.com
B
RY
ARS
Page 1 of 5
Advertisement
Table of Contents
Related Manuals for Vestil PLBS Series
Summary of Contents for Vestil PLBS Series
- Page 1 2) VESTIL is not liable for any injury or property damage that occurs as a consequence of failing to apply either: a) Instructions in this manual; or b) information provided on labels affixed to the product.
- Page 2 Safety Recommendations: Vestil diligently strives to identify foreseeable hazards associated with the use of its products. However, material handling is inherently dangerous and no manual can address every conceivable risk. The end-user ultimately is responsible for exercising sound judgment at all times.
- Page 3 The cotter pin should be undamaged and securely attached to the axle pin. 3. Product labels: all labels should be readable and located as shown in the “Label placement diagram” on p. 4. If a label(s) is unreadable or missing, contact Vestil to order a replacement. Copyright 2014 Vestil Manufacturing Corp.
- Page 4 The product should always be labeled as shown in the diagram below. Replace any label that is damaged or not easily readable. Label 287: Model, serial no., capacity (applied to back side of plate) Copyright 2014 Vestil Manufacturing Corp. Page 4 of 5...
- Page 5 (you) for warranty service. Who may request service? Only a warrantee may request service. You are a warrantee if you purchased the product from Vestil or from an authorized distributor AND Vestil has been fully paid.
Need help?
Do you have a question about the PLBS Series and is the answer not in the manual?
Questions and answers