Haier HWD80-BP14636N User Manual page 19

EN
6.10 Start wash programme
Press "Start/Pause" button (Fig. 6-10) to start. Appli-
ance operates according to present settings. Changes
are only possible by cancelling the programme.
Note: Door lock
For safety reasons the door is locked partially during the washing /drying cycle. It is
only possible to open the door at the end of the programme or after the programme
was cancelled correctly (see description above).
In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door;
6.11 Interrupt - cancel wash programme
To interrupt a running programme press gently "Start/Pause". The LED above the button
is flashing. Press it again to resume operation.
To cancel a running programme and all its individual settings
1. Press "Start/Pause" button to interrupt the running programme.
2.
3. Press "On/Off" button to turn on the appliance, select programme Spin and then se-
lect "no Speed"(speed lights are off) , start the machine to drain the water.
4. After closing the programme to restart the appliance, select a new programme and s-
tart it.
6.12 After washing
1. At programme cycle end
2.
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4.
5. Unplug the power cord.
6. Open the door to prevent formation of moisture and odours. Let it open while not used.
Note: Cool down cycle for drying cycle
The last part of the drying cycle occurs without heat to ensure remaining the garments
at a temperature which does not damage them.
Note: Standby mode / energy-saving mode
The switched on appliance will go into standby mode if Pause-button is pressed. This
Pause" button.
is displayed.
Loc 1-
is displayed.
EnD
6- Daily use
Start/Pause
6-10
19