Gigabyte GA-Z270MX-Gaming 5 User Manual page 16

8) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
S _
RAID 1, RAID 5, and RAID 10. Refer to Chapter 3, "Configuring a RAID Set," for instructions on configuring
a RAID array.
5 3 1
SATA3
4 2 0
7
7
S _
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Peripherals\SATA
And RST Configuration," for more information.
9) U2_32G (U.2 Connector)
The U.2 connector supports a single U.2 device. Please note that an U.2 SSD cannot be used to create
a RAID set either with an M.2 SATA SSD or a SATA hard drive. To create a RAID array with an U.2 SSD,
you must set up the configuration in UEFI BIOS mode. Refer to Chapter 3, "Configuring a RAID Set," for
instructions on configuring a RAID array.
U
B_
Pin No. Definition
1
1
B_
- 16 -
_
S _S
Chipset supports RAID 0,
®
1 GND
2 TXP
3 TXN
_
4 GND
5 RXN
6 RXP
7 GND
USB 0_ B
_
B_
_B