Advertisement
HOW TO USE
Wash all detachable parts and dry well before using the appliance for the first time, refer to page 8. Unplug
when assembling the unit. Before plugging in, ensure Switch is switched OFF.
1 Place the Container Unit onto the Motor
Housing.
Make sure the Spout and the Clamp (both
side) positioned same direction as illustrated.
Make sure the Container Unit sits properly
on the Motor Housing.
5 Place the juicer as shown.
Make sure the Spout is in the downward
position when juicing.
It is recommended to use a similar mug as
shown to promote ease of use.
6 Plug in and switch ON.
7 Insert the ingredients one by
one and push them slowly
into the Feeding Tube using
the Food Pusher.
6
Note:
• Ingredients that are not recommended:
Soft fruits that produce puree and can clog the Spinner – e.g. bananas, peaches, apricots etc.
Low juice ingredients which can block the product – e.g. fresh basil leaf etc.
Hard ingredients which can cause product malfunction - e.g. sugarcane, coconut etc.
• Please remove hard seeds and stones from fruit before juicing such as guava etc. Hard seeds that are
difficult to be removed such as pomegranate is prohibited for juicing.
• During initial usage, the appliances might have some unpleasant smell (slight burn smell) but this
condition is normal.
• Some ingredients may produce a lot of pulps that will accumulate to the Container Cover which will
cause operation to stop. (CIRCUIT BREAKER PROTECTION: refer to page 6)
• Make sure all parts are correctly mounted before you switch ON the appliance.
• Some ingredients may accumulate at the Container Cover and Spinner. If so, please switch OFF the
juicer and clear the accumulated ingredient before continuing to juice to prevent leakage.
2 Place the Spinner in the
Container Unit and fix it
into position.
3 Place the Container Cover
onto the Container Unit.
4 Rotate the Clamp (both side) as
shown while pushing the Container
Cover until a locking sound is heard.
It is normal for the Container
Cover to float a little causing
a small gap between Container
Cover and Container.
Make sure hand or fingers are
not in the way during the
clamping process to avoid
injury.
8 After use, switch OFF and unplug.
Ensure the Spinner is fully stopped before
pushing the Spout up to prevent juice from
dripping when removing the cup from the
Juicer.
Ensure the Spinner is fully stopped before
releasing the Clamp (both side).
Some pulp might resides on the Container
Cover depending on the ingredients and
amount.
7
3
2
Gap
7
Advertisement
