Advertisement
3. Remote control buttons
Faster
Power off
Steer left
Power on
Slower
Pairing
3. Pairing remote to motor
Press and hold
below the battery status
lights on the motor (fig. 9) and
(also the
Slower button) on the remote at the same time
for three (3) seconds or until you hear 3 beeps
indicating that connection has been made and
the remote and motor are paired. Release
fingers from both buttons.
4. Mode signal light
1.
Press the 'ON' button, indicator light is on solid or flashes,
remote control is on 'standby' state.
2.
Press any button on the remote control, red indicator light
flashes, indicating signal is sending.
3.
Select
button, light is two-tone pink/purple, indicating
motor is in the anchor mode.
4.
Press 'OFF' button to turn of remote control. Light is now off.
(Fig. 10)
If your press the 'ON' button and there is no indicator light or is solid
red, please recharge the remote control as the battery is flat.
Remote control
Mode signal light
Full speed
Motor On/Off
Steer right
Anchor
Pairing button
Pairing button
Fig. 9
Fig. 10
Speed control
Press
to activate the motor. Press
to adjust the motor's speed. To stop the motor,
press
to cancel. (Fig. 11)
Steering control
Press
or
to steer the motor direction
left or right. (Fig. 12)
Full speed
Press
to select full speed (turbo mode). Press
again to return to the prior speed setting. (Fig. 13)
Spot lock (anchor mode)
Press
to select spot lock (anchor) function
to anchor the boat in position. Press
again to
disengage anchor function, will return the motor
to the stop mode. Press
and
to select
speed. (Fig. 14)
10. Lanyard
For your convenience the lanyard can be configured to suit
your preference ie around the neck or use the carabiner to clip
to a belt loop. (Fig. 15)
Using the remote
or
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Advertisement
