Accessing Stored Data - OWIM HG01106A Operation And Safety Notes

Press the ALARM-/SET button again to confirm your entry, and he
minutes will start flashing. These can be changed in the same manner.
Activating the alarm
In clock mode press the DOWN- /
the time a bell will appear with 1:
Press the DOWN- / -button again and the alarm symbol 1 will
disappear. Alarm symbol 2:
DOWN- / -button again will activate alarm 1 and alarm 2. Both
alarm symbols will appear:
ton a fourth time will deactivate both alarm 1 and alarm 2.
Switching off the alarm
The alarm will sound at the set time and the backlight will switch
on. When not switched off, the alarm will sound for 2 minutes
before stopping automatically.
Press the SNOOZE-/LIGHT field
display will flash
has been activated: the alarm will sound again after 5 minutes.
Press any button on the keypad to actually shut off the alarm.

Accessing stored data

Maximum temperatures
Press the MEM button again and both temperature fields will show
and next to the temperature, and MAX next to the humidity. The
24
respective maximum indoor and outdoor value will be shown. Press
the MEM button twice and MIN will appear next to the temperature,
and the respective lowest indoor and outdoor value will be shown.
After 5 seconds the current values will again be displayed.
TIP: Min / Max Temperature are measured by all time since start (af-
ter batteries inserted / power supply connected). To erase the stored
Min / Max Temperature, hold the MEM button for approx. 3 seconds.
-button
. Alarm 1 is now activated.
. will appear. Pressing the
. Pressing the DOWN- / -but-
to interrupt the alarm. The clock
2
/
, indicating the snooze function
. In addition to
15
GB
23
23