Epson EPL-6100 Reference Manual page 147

Toner Out
Allows you to set whether the printer should continue or stop
printing when the printer encounters a Toner Out error. If set to
Continue (default), the printer continues printing regardless of
the error. This setting is recommended if you are physically
distant from the printer. If set to Stop, the printer stops printing
when it encounters the Toner Out error.
Image Optimum (LaserJet4 only)
Allows you to print complex graphics even when print data
reaches the memory limit. When set to On, the amount of graphics
data is automatically reduced, allowing complex documents to be
printed. However, the quality of the graphics is reduced.
Tray Assign
Changes the assignment for the paper source select command.
When 4 is selected the commands are set as compatible with the
HP LaserJet4. When 4K is selected the commands are set as
compatible with the HP LaserJet 4000, 5000, and 8000. When 5S
is selected the commands are set as compatible with the HP
LaserJet 5S.
MP Tray Size
Allows you to set the paper size for the MP tray. The options are
the same as those under Page Size. This setting affects the setting
under other emulation modes as well.
Paper Type
Allows you to specify the type of paper to improve print quality.
Thick W (188 mm wide or wider) is for paper with a width of more
than 188 mm. Thick N (less than 188 mm wide) is for thick and
narrow paper like envelopes. Transparency is for transparencies.
Always use Normal (default) unless print quality problems occur.
Using the Remote Control Panel Utility
7
7
7
7
7
7
7
7
7
7
7
7
45