Advertisement
Troubleshooting
Problem
Possible Causes
Tool will not start.
Cord not connected.
No power at outlet.
Tool is overheated.
Tool operates
Forcing tool to work too
slowly.
fast.
Using incorrect extension
cord size.
Performance
Bits or blades dull or
decreases over
damaged.
time.
Tool is
Forcing tool to work too
overheating.
fast.
Bits or blades dull or
damaged.
Blocked vents.
Motor being strained by
long or small diameter
extension cord.
10
Likely Solutions
Check that cord is plugged in.
Check outlet and circuit breaker.
Turn off, unplug and let tool cool
down.
Allow tool to work at its own
rate.
Use proper size extension cord.
Replace bits or blades as
needed.
Allow tool to work at its own
rate.
Replace bits or blades as
needed.
Clear vents.
Use proper size extension cord.
wards.com
________________________________________________________
________________________________________________________
________________________________________________________
________________________________________________________
________________________________________________________
________________________________________________________
________________________________________________________
________________________________________________________
________________________________________________________
________________________________________________________
________________________________________________________
________________________________________________________
________________________________________________________
1
•
Notes
888
557
3848
•
•
11
Advertisement
