Anti-mite measures for futon
●
Anti-mite takes 90 minutes for a half of one side of the futon.
It takes approximately 6 hours for one set of the futon (1 comforter and 1 mattress).
1
Insert the nozzle
between the comforter and mattress.
●
At the position of 1/4 from the edge
of the futon length, insert the nozzle
completely to the futon.
(Otherwise, the effect may not be
obtained as expected.)
2
Connect the power plug,
press
●
Each press of the button will switch to the next timer setting.
(The timer indicator and the operation indicator (Winter) light up.
●
The operation starts immediately after pressing the
button. (approximately 90 minutes)
3
After the operation stops, to take anti-mite for
the remaining part of futon,
press
●
The operation starts immediately after pressing the button.
(approximately 90 minutes)
4
Turn over both of the comforter and mattress,
repeat steps
●
The operation stops* when the preset time has passed.
●
After all the operation is completed, disconnect the power plug, and
store the hose, nozzle and power cord into the body. (P.23)
5
Clean the futon with a vacuum cleaner.
●
To reduce the risk of allergy, suck the dead mites and feces in the futon with a vacuum cleaner.
Using the attachment for vacuum cleaner like "futon nozzle" may be more effective.
To stop the operation
in the middle
press
.
●
The operation stops*.
●
Anti-mite measures may not be done completely, because the temperature at the corner of the futon is lower.
Notice
●
Depending on the type of mite, anti-mite measures may be ineffective.
and select "
" (90 min.).
again and select "
1
to 3.
* After the operation stops, the operation indicator (Winter) may flash and the fan may
continue operating for up to 2 minutes to cool down the product (nozzle and hose).
Disconnect the power plug after the indicator stops flashing and the fan operation
stops completely.
WARNING
WARNING
1/2
1/2
" (90 min.).
Do not touch the nozzle or hose
immediately after operation.
(May cause burns.)
Do not block the air
outlet.
(May cause a fire due to
overheating.)
1/4
1/4
FR061
25