Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Installer Setting - Setting Address of Central Control
Installer Setting - Checking Address of Central Control
1
With the PLASMA button pressed, press the RESET button.
2
Press the ON/OFF button toward the indoor unit 1 time, and the indoor unit will
display the set address in the display window.
- The address display time and method can differ by the indoor unit type.
3
Reset the remote controller to use the general operation mode.
1
With the MODE button pressed, press the RESET button.
2
By using the TEMPERATURE SETTING button, set the indoor unit address.
- Setting range : 00 ~ FF
Group No.
Indoor Unit No.
3
After setting the address, press the ON/OFF
button toward the indoor unit 1 time.
4
The indoor unit will display the set address to complete the address set-
ting.
- The address display time and method can differ by the indoor uint type.
Reset the remote controller to use the general operation mode.
5
INSTALLATION INSTRUCTIONS
17
Advertisement
Table of Contents
