Table of Contents
Advertisement
What to do in the event of a fault
en
Ice maker
The ice maker is not functioning.
Ice cube production is switched off.
Freezer compartment is too warm.
Ice cube container is not properly inserted.
The ice maker is without power.
No water supply.
Low water pressure.
Kink in water hose.
Too few or deformed ice cubes, water pressure lower than usual.
After switching on or removing many ice cubes, there will be
too few in the ice cube container.
Ice cube production stops even though the ice cube con-
tainer is not yet full.
Low water pressure.
The water filter is blocked or needs to be replaced.
Freezer compartment is too warm.
Water is leaking out of the appliance.
Water connection is not watertight.
--------
28
Switch on ice cube production.
Set the temperature lower.
"Operating the appliance" on page 14
~
Insert ice cube container fully.
Call Customer Service.
Check water connection and contact technician if necessary.
Only connect appliance to pipes with sufficient water pres-
sure.
Turn off water supply, straighten out kink. Replace water hose
if necessary.
It takes around 24 hours for an empty ice cube container to fill
up.
Do not store the ice shovel on the ice in the ice cube con-
tainer. Otherwise, the sensor will not detect the actual fill level
of the container.
Only connect appliance to pipes with sufficient water pres-
sure.
Change water filter.
Set the temperature lower.
"Operating the appliance" on page 14
~
Check that the connections are fastened firmly and the water
hose is undamaged.
If the water hose is damaged, contact Customer Service and
have it replaced. Replacement must be performed by Cus-
tomer Service or a similarly qualified person.Use original
parts supplied by the manufacturer only.
Advertisement
Table of Contents
