Page 8
Jump Start Red LED Troubleshooting Green / Red LED STATUS BOOST Jumper cable signal Cause Status Sound Solid Green Red & Green Jump started 4 consecutive times within light flashes 10 minutes. alternately Red light Over-voltage protection. flashes rapidly Red light Over-current protection flashes slowly 1.
Page 9
Solutions Jump start the vehicle. Do not jump start more than 4 times. Disconnect the clamps from the vehicle’s battery. Unplug the jumper cable from the jump starter. Consult a mechanic. Disconnect the jump starter and jumper cable from the vehicle. The vehicle’s battery voltage is higher than applicable.
Page 10
Charging Portable Devices 1. Connect your portable device with one end of the USB cable, and insert the other end to one of the output ports: USB-A 1, USB-A 2 or Type-C port, of the jump starter. Note: to use the fast charging function, please use the Type-C port. 2.
Using the Flashlight 1. To switch on the flashlight, press and hold the ON/OFF button for 2 seconds. 2. Press the ON/OFF button once to toggle through 4 light settings: Flashlight, SOS, White Flood Light, and Red Alert Strobe. 3. Press and hold ON/OFF button for 2 seconds to switch off the flashlight.
Use the accessories that are provided in the package. Shell is not responsible for any damage or injury when using accessories that are not provided by us.
Personal Precautions Wear adequate eye protection and protective clothing when working near a vehicle battery. Do not smoke or allow a spark or flame near the battery or engine. Remove all metal objects such as rings, bracelets, and watches. Have plenty of fresh water and soap nearby in case of battery acid contact with eyes, skin or clothing.
EXTENT ALLOWED BY SUCH LAWS. This Limited Warranty is made solely for the benefit of the original purchaser of the Product from Shell or its approved reseller or distributor and is not assignable or transferable. To make a warranty claim, the purchaser must: (1) request and obtain a return merchandise authorization (“RMA”) number...
Page 15
Shell’s recommendations for safe and effective use; (b) improperly installed, operated or maintained; (c) are/were modified without the express written consent of Shell; (d) have been disassembled, altered or repaired by anyone other than Shell; (e) had defects which were reported after the Warranty Period.
Need help?
Do you have a question about the SH912 and is the answer not in the manual?
Questions and answers