Cardinal Gates WG35 Assembly Instructions

ASSEMBLY INSTRUCTIONS
GATE IS RECOMMENDED FOR CHILDREN BETWEEEN 6 AND 24 MONTHS.
A
B
D
C
1
A
C or J
6 "
3
3. Insert eye bolts with nut and washer (E)
into top and bottom of hinge side gate.
Be sure nuts are tight.
5
OPTION
ONE-WAY
STOP BRACKET
5. Mount latch assembly (H) to gate using 3/4" bolts with serrated
washers (D). Attach wall mount for latch assembly (G) up
into part (H) that is now secure on gate. Slide gate out to
mark holes for (G) on attaching wall. (*OPTIONAL ONE WAY
BRACKET INSTALLED HERE) Then attach the wall mount of
latch assembly to wall using Phillips head screws (C). Optional
long screws (J) maybe be used to attach gate to stud through
dry wall.
SEE REVERSE FOR GATE
OPERATION
INSTRUCTIONS
INTENTED FOR USE WITH CHILDREN FROM 6 MONTHS - 24 MONTHS. THIS PRODUCT WILL NOT PREVENT ALL ACCIDENTS.
WOOD GATE - MODEL WG35
FOR OPENINGS 29" (73cm) - 49.25" (125cm)
F
E
1. Install hinge bracket
(A) to wall (stationary
side of gate) using
Phillips screw (C)
beginning 6 " above
floor surface. (Use
ruler on left edge of
this sheet to measure
from floor).
OPTION: Long
screws (J) maybe be
used to attach gate to
stud through dry wall.
E
2X
H
D
G
L
D
OPTION
ONE-WAY
STOP BRACKET
G
H
2
C or J
B
4
I
4. Hang gate by inserting hinge rod (B), through top
of mounted hinge bracket (A), through both eye bolts,
and finally through bottom of hinge bracket. To secure
hinge, insert key ring (I) through hole in end of hinge
6
6. Set gate to approximate width.
Use Allen wrench (F ) to insert set
screws ( K ) and tighten top and
bottom of gate.
IF GATE IS INSTALLED AT TOP OF STAIRCASE:
Install one-way stop bracket (L ) on one side of
wall mount latch to have gate open in only one
direction for maximum safety.
2012
J
K
OPTION
I
ONE-WAY
STOP BRACKET
L
2. Install second
screw (C) in
top of hinge
bracket
securing it to
the wall.
K
F
2X
REPEAT AT TOP AND
BOTTOM OF GATE TO
SET GATE WIDTH