Cardinal Gates WG35 Assembly Instructions

ASSEMBLY INSTRUCTIONS
GATE IS RECOMMENDED FOR CHILDREN BETWEEEN 6 AND 24 MONTHS.
A
B
D
C
1
A
C or J
6 "
3
3.
Insert eye bolts with nut and washer (E)
into top and bottom of hinge side gate
(side with three holes). Be sure nuts are
tight.
*
5
OPTION
ONE-WAY
STOP BRACKET
5. Mount latch assembly (K) to gate using 3/4" bolts with serrated
washers (D). Attach wall mount for latch assembly (H) up
into part (K) that is now secure on gate. Slide gate out to
mark holes for (H) on attaching wall. (*OPTIONAL ONE WAY
BRACKET INSTALLED HERE) Then attach the wall mount of
latch assembly to wall using Phillips head screws (C). Optional
long screws (J) maybe be used to attach gate to stud through
dry wall.
FOR MAXIMUM SAFETY,
ALWAYS KEEP GATE
LATCHED AND CLOSED.
NEVER USE TO KEEP CHILD AWAY FROM POOL. THIS PRODUCT WILL NOT PREVENT ALL ACCIDENTS.
WOOD GATE - MODEL WG35
FOR OPENINGS 29 " (75cm) - 49¼" (125cm)
G
E
1. Install hinge bracket
(A) to wall (stationary
side of gate) using
Phillips screw (C) drill
pilot hole 6 " above
floor surface.
OPTION: Long
screws (J) maybe be
used to attach gate to
stud through dry wall.
E
K
D
*IMPORTANT:
Make sure this
side of bracket
id of ra
is
H
installed to the
wall!
M
D
OPTION
ONE-WAY
STOP BRACKET
GATE IS RECOMMENDED FOR CHILDREN BETWEEN 6 AND 24 MONTHS.
H
K
2
C or J
4
4. Hang gate by inserting hinge rod (B), through top
of mounted hinge bracket (A), t rough both eye bolts,
and finally throughbottom of hinge bracket.
To secure hinge, insert key ring (I) through hole
up to 30 degrees.
6
s s
t
when
to e
6.
IF GATE IS INSTALLED AT TOP OF STAIRCASE:
Install one-way stop bracket (M) on one side of
M
wall mount latch to have gate open in only one
direction for maximum safety.
J
OPTION
ONE-WAY
STOP BRACKET
2. Install second
screw (C) in
top of hinge
bracket
securing it to
the wall.
B
I
L
G
2X
REPEAT AT TOP AND
BOTTOM OF GATE TO
SET GATE WIDTH
Keep gate closed and latched. Use
Allen wrench (G) to insert set screws
(L) in the upper and lower brackets
of the gate. Tighten the set screws
to set the width of the gate.
I
M
L
NOV 2017