Sencore MIP 6210 Quick Start Manual

Quick Start Guide

About This Quick Start Guide

This guide is for helping new customers get their Sencore MIP 6210 setup and
running as quickly and easily as possible.
The MIP 6210 High-Rate IP Streamer aids in the design, verification,
manufacturing, and deployment of digital TV equipment and systems. The ability
to play out hundreds of media streams at Gigabit rates makes it the ideal solution
for the development and deployment of IPTV systems. It further serves as a
reliable signal source for qualifying IPTV networks and digital television
equipment. With its full line-rate performance, the MIP 6210 is the ideal tool to
test the limits of networks and IP devices.
Download the Full User's Manual
The current versions of the full user's manuals can be obtained from the
Download tab of individual product pages on our website:
by emailing Sencore ProCare support at procare@sencore.com.

Unpack the Equipment

Check that there are no signs of damage to equipment due to transport. If the
equipment appears to be damaged, please contact Sencore ProCare for support.
In addition to the Sencore MIP 62120 server hardware itself, the box should
include a power cables and various rackmount hardware.

Equipment Installation and Power Up

The MIP 62120 server hardware is designed for rack installation and should be
securely connected to the rack using the included rack rails and screws suitable
for the rack type. Note that there should be sufficient room for air to freely flow
around the unit, ensuring proper cooling. The chassis requires front-to-back
airflow.
The MIP 62120 server hardware is specified to operate in the range of 100–
240VAC, 50-60Hz.
Form 8172A
MIP 6210
www.sencore.com or
Version 1.1 - June 2020
2
1
3
Figure 1: Rear Port Connectors
1. Power Connector: Provides AC power connection for powering the
system
2. IPMI Port: Can be used for remote server management, but not
normally used in the MIP 6210 operation
3. eth0 Port: Network port for management and streaming.
4. eth1 Port: Network port for management and streaming.
5. eth2 Port: Port available only with the addition of optional card adding
either 2x RJ45 or 2x SFP ports
6. eth3 Port: Port available only with the addition of optional card adding
either 2x RJ45 or 2x SFP ports
7. VGA Monitor Output

Establish a Web Connection to the MIP 6210

In order to access the MIP 6210 web user interface, it is necessary to establish
an Ethernet connection to the device. There are two alternative ways to connect
to or set the device's management IP address: using the pre-set management IP
address or connecting a monitor and keyboard to the server.

Using the Pre-Set Management IP Address

The Sencore MIP 6210 is shipped with the following factory settings for the
network ports:
eth0 Default IP Address:
eth0 Default Subnet Mask:
5 6
7
4
10.0.20.101
255.255.0.0
Page 1